High quality alloy wheels wholesale manufacturer

Alloy rims factory with Jjjwheel: Some businesses on the market do not need to promote the center of the modified hub of the ring, personally think that marketing gimmicks are greater than the actual effect. For hubs that require the use of a center ring, just use the appropriate size of the center ring. No problem at all in daily driving! Mistake : ignore the hub installation step, the hub is not properly installed. Many friends to change the wheel hub, wheel hub online shopping with very excited mood must not immediately drive to the store installation, expecting the wheels finally arrived and then install immediately without any inspection. Find even more information on wholesale alloy wheels.

The two piece wheel consists of two parts: the rim (Barrel), and the wheel width. It is possible to combine different rim widths and thicknesses on one hub, or to combine widths and offsets for more options. And the two spokes are interchangeable, so that when repairing and replacing, it is not necessary to replace the whole hub, but only the part, which is finally fastened with high-strength bolts. This is the most primitive processing method for aluminum alloy wheels, which can be formed by pouring high-temperature liquid metal into the mold and cooling it. This method is efficient and low cost, but the uniformity of each part of the manufactured wheel is poor, and the molecular density is relatively low, resulting in low strength, so it is not very suitable for high-strength use of passenger vehicles.

One is size: don’t blindly increase the hub. Some people increase the wheel hub to improve the performance of the car. Under the condition that the outer diameter of the tire remains unchanged, the large wheel hub is bound to match the wide and flat tire. The lateral swing of the car is small, and the stability is improved. pass by. However, the flatter the tire, the thinner the thickness, the worse the shock absorption performance, and the greater the sacrifice in terms of comfort. In addition, the tires are easily damaged if there are some roadblocks such as stones. Therefore, the cost of blindly increasing the hub cannot be ignored. Generally speaking, it is most appropriate to increase one or two sizes according to the size of the original wheel hub.

Pure electric vehicles are driven by electric motors. Unlike fuel vehicles, the engine combustion is not only loud, but also vibrates greatly. When pure electric vehicles are driving, there is no obvious shaking, and the front of the car does not need an air intake grille. Very quiet in the car. Of course, to drive a pure electric car, you need to master the switch. Many people are prone to motion sickness. Many people are used to driving a fuel car. When you start off with a kick of the switch, the power comes fast, the linearity is very strong, the speed is fast, and the back feeling is full. When braking, the switch is closed, and the power recovery function is added, and the power is lost instantly, and the head-up and nodding movements are more obvious.

One piece forged wheels,Milling and forging,The use of impact or pressure to deform the metal between the upper and lower two against the iron (anvil) to obtain the required block of blanks, blanks after heat treatment and then through the machining center milling and forming, a piece of relatively lighter weight, can achieve the most lightweight dynamic balance better reliability, no hidden gas leakage. The main advantages of steel hubs are simple manufacturing process, relatively low cost and strong resistance to metal fatigue. But the disadvantages are also obvious, such as heavy weight, large inertial resistance, poor heat dissipation and so on.

We not only have the traditional low-pressure casting technology, but also have the high strength and light weight manufacturing technology of “low-pressure casting + spinning”. We always maintain various advanced technology advantages in aluminum alloy wheel manufacturing to meet customers’ needs and lead the industry development. The formula has perfect testing equipment, including material testing machine, hardness tester, solid aluminum alloy containing slag quantitative tester, X-ray diffractometer, bending fatigue tester, radial fatigue tester, biaxial fatigue tester, 13° impact tester, 30°/90° impact tester, salt spray test chamber, humidity and heat test chamber, etc., which can carry out the four major testing areas of wheels (dimensional testing, alloy material performance, reliability and safety, coating. See additional info on https://www.jjjwheel.com/.